Assembly Steps - Sauder 428397 Instrucciones De Montaje

Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
the RIGHT END (A) until the shoulder of the SCREWS rest
on the surfaces of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide an END MOLDING (F) onto the RIGHT END (A). Line
up the groove in the MOLDING over the heads of the
SCREWS in the END.
å
NOTE: The MOLDING should be even on both edges of
the END.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
å
Repeat this step using the LEFT END (B).
www.sauder.com/service
BLACK 9/16" FLAT HEAD SCREW
A
428397
32S
(4 used in this step)
F
Shoulder
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 5