Notes On Cleaning And Maintenance - TILSBERK DVISION Manual De Instrucciones

2.4 Notes on cleaning and maintenance

Avoid dirt
Try to avoid stubborn dirt. In particular oil and fuel, but also sticky liquids damage the device.
Observe the following notes:
// If possible, store and transport your DVISION in the protective cover provided or leave it
mounted in the helmet.
// Make sure your hands are free from oil and fuel residues when you touch the display and optical
output area.
Cleaning the DVISION module
You can't always avoid dirt. Humidity, dust and particles in the air settle on the surface of the device.
If you want to clean your device, proceed as follows:
1. Remove the DVISION module from the helmet.
2. Use the protective cover provided or a clean microfibre glass cleaning cloth to thoroughly clean
the DVISION module. In particular, make sure that there is no dirt on the light sensor or the
display.
3. To remove stubborn dirt, lightly moisten the protective cover or glass cleaning cloth with clear
water. Do not use chemical detergents.
4. If you are unable to remove dirt, contact the manufacturer and discuss what to do next
("Manufacturer's contact details" on page 1).
Once the light sensor and display are free from dirt and function correctly, the cleaning of
the DVISION module is complete.
Cleaning a helmet with an installed helmet adapter
To clean your helmet, remove the DVISION module from the helmet. You can clean the outside
of your helmet as you normally would when the helmet adapter is installed. Follow the helmet
manufacturer's instructions when doing so.
If the helmet adapter is affixed to the fabric of the lining, do not wash the lining in the washing
machine.
NOTE!
Do not use pressurised air or chemical detergents to clean the
DVISION module. Pressurised air and chemicals can damage the surfaces
of the display and the optical output area as well as their function.
S A F E T Y
EN
12