TILSBERK DVISION Manual De Instrucciones página 18

1. Use a flat object, e.g. a plastic card or ice cream stick to check if the gap has sufficient space for
the tabs of the helmet adapter.
2. If there is sufficient space in the gap and the object is wedged in the gap, proceed with
mounting variant A (Chapter 3.3 on page 19).
3. If the gap is too small or cannot be opened at all, proceed as though your helmet had a sun
visor ("Decision guide: selecting the helmet adapter" on page 15).
Material types
FIGURE 7 //
Examples of materials for helmets with material on the mounting surface
1
Course mesh material
2
Leather or artificial leather
3
Fine mesh material (for example, viscose or microfibre)
If the material of the helmet padding extends to the mounting surface, check the type and flexibility
of the material.
1. Try to gently twist and stretch the material with two fingers.
2. If the material is smooth and hard to grip and stretch, the mounting surface of your helmet is
tight. Continue with mounting variant C (Chapter 3.5 on page 24).
3. If the material can be stretched, check if the helmet adapter with tabs fits into the gap for the
sun visor without colliding with the sun visor.
INFO
For some helmets, you first have to open up the gap a little bit. The gap
should be easy to open by pulling the outer shell of the helmet with
your hands.
I N - H E LM E T I N STA L L AT I O N
1
2
3
EN
17