Switching On And Off; Starting The Navigation - TILSBERK DVISION Manual De Instrucciones

Switching on and off

1. To switch on the DVISION module, push the operating button for approx. 1 second.
The DVISION module is being activated. The LED flashes once.
2. To switch off the DVISION module, push the operating button for approx. 3 seconds.
The DVISION module is being deactivated. The LED flashes twice.
Pairing mode
The DVISION module is constantly in pairing mode, but can only be connected to one smartphone
at a time. After the initial coupling, the DVISION module automatically connects to the paired
smartphone if it is within reach of the Bluetooth signal and Bluetooth has been activated. If you want
to pair your DVISION module with another smartphone, ensure that there is no paired smartphone
nearby, or switch off Bluetooth on the already paired smartphone.

4.3 Starting the navigation

Use the DVISION app to select your destination and route settings, and let the DVISION module guide
you to your destination.
Before you start your ride
1. Sufficiently charge your DVISION module and smartphone for the estimated duration of your
ride.
2. Ensure that you have sufficient mobile data for the ride. An unstable internet connection can
affect navigation.
If you are not sure or you are likely to spend significant time in areas with limited reception, you
can download the map material for your route prior to starting your ride.
3. Clean the display. Streaks or dirt on the display can affect your vision during the ride.
WARNING!
Inattentiveness in traffic can lead to accidents and serious injuries!
Focus on your ride during the entire trip.
Make all route settings and preparations before you start riding.
If you want to make settings in the DVISION app during your ride,
pull over when it's safe to do so and get off your motorbike.
O P E R AT I O N
EN
37