Mounting Variant B: Gluing In The Helmet Adapter With Tabs - TILSBERK DVISION Manual De Instrucciones

3.4 Mounting variant B: gluing in the helmet adapter with tabs

Video instructions
Detailed video instructions for installing DVISION in helmets using adhesive pads are available on
the internet. To access, scan the QR code or call up the video via the browser link.
dvision-hud.com/install/b
Required components
For this mounting type, you need the following components from the scope of delivery:
// DVISION module
// DVISION helmet adapter with tabs
// Set with adhesive pads for DVISION helmet adapter with tabs
Installing the helmet adapter
FIGURE 10 //
Gluing in the helmet adapter with tabs
1. Apply the large adhesive pad (FIGURE 10/1) to the side of the helmet adapter (FIGURE 10/2) on
which you can see the magnets.
2. Apply the small adhesive pads (FIGURE 10/3) to the insides of the tabs.
3. Place the helmet adapter (FIGURE 10/2) in the forehead section of the helmet between the
interior shell (FIGURE 10/4) and the sun visor (FIGURE 10/5). At the front of the helmet adapter,
there is a mark (FIGURE 10/6) that should be placed on an imaginary line between the middle of
your helmet and the middle of your face. Make sure the helmet adapter does not collide with
the sun visor.
I N - H E LM E T I N STA L L AT I O N
5
4
2
6
1
EN
8
7
3
21