TILSBERK DVISION Manual De Instrucciones página 29

Preparing Sugru
1
FIGURE 13 // Applying Sugru to the narrow helmet adapter
Sugru hardly needs any preparation to develop adhesive properties. The adhesiveness develops
through the reaction of the material with the ambient air.
Once the pack is opened, you have 30 minutes to work with Sugru.
Sugru requires 24 to 48 hours at room temperature to fully set and develop its maximum adhesive
force. The exact time required depends on the thickness of the layer as well as the ambient
temperature and humidity.
1. Open a pack of Sugru and remove the content (FIGURE 13/1) from the package.
2. Divide the Sugru into two halves (FIGURE 13/2a and 2b).
3. Use one half to the Sugru (FIGURE 13/2a) to form a roll (FIGURE 13/3) that is approximately as long
as the helmet adapter.
4. Split the other half of the Sugru (FIGURE 13/2b) into two equal parts and roll both of them into
balls (FIGURE 13/4).
5. Place the roll (FIGURE 13/3) on the side of the helmet adapter on which you can see the magnets
(FIGURE 13/5).
2a
4
2b
INFO
Sugru is non-irritating to skin. If you experience an allergic reaction
after skin contact, rinse the skin with warm water. Follow the
manufacturer's instructions.
I N - H E LM E T I N STA L L AT I O N
3
6
EN
5
28