In-Helmet Installation; Installation Instructions; Mounting Surface; Preparing The Installation - TILSBERK DVISION Manual De Instrucciones

3

In-helmet installation

3.1

Installation instructions

Before your DVISION can guide you to your destination, you have to install it in your helmet.
The following section helps you prepare for installation and choose the right mounting type for your
helmet.

Mounting surface

FIGURE 4 //
Mounting surface (example)
The helmet adapter is mounted on the flat surface in the forehead area of the helmet (FIGURE 4/1).
Following that, the magnets are used to affix the DVISION module to the helmet adapter.

Preparing the installation

There are several options for attaching the helmet adapter to the helmet. The right option for your
helmet depends on the shape of the helmet and the materials used in the helmet. The right type
of attachment for your helmet should ensure the best possible hold strength and should affect the
functionality of the helmet as little as possible.
To correctly prepare the installation, proceed as follows:
1. Determine your helmet type and the appropriate mounting variant (FIGURE 5).
INFO
The pages after the decision guide (FIGURE 5) provide examples of
different helmet types and material types as well as details on how to
select a mounting variant (Chapter "3.2 Examples of helmet types", p. 16).
I N - H E LM E T I N STA L L AT I O N
EN
1
14