TILSBERK DVISION Manual De Instrucciones página 23

4. Evenly push the helmet adapter with the adhesive pads onto the helmet.
5. Check whether the helmet adapter sits correctly on the helmet. To do so, use the magnets to
attach the DVISION module to the helmet adapter.
The DVISION module must lie flush against the helmet adapter, without any visible gap between
the two.
Checking the position of the helmet adapter
6. Fold down the sun visor to check that the sun visor does not collide with the helmet adapter or
the DVISION module.
7. Put your helmet on as usual.
8. Attach the DVISION module to the helmet adapter using the magnets and fold down the display
at a 45° angle.
The display should be well visible in front of your right eye.
9. Push the operating button on the DVISION module to switch on the device.
A screen appears on the display.
10. Check if you can clearly see everything on the display in its entirety
INFO
If you notice that individual tabs collide with the helmet material,
you can simply break off up to three tabs (FIGURE 10/7, for example).
The helmet adapter is perforated at the lower edge of the tabs
(FIGURE 10/8) to facilitate break off.
without changing the position of the helmet on your head. To do so, look
ahead as you would if you were riding in traffic:
// The display should be well visible in front of your right eye.
// The display should be clear and easy to read.
// The entire screen should be within your field of vision. Use the frame
for orientation when switching on the DVISION module.
INFO
You can show the frame again for alignment orientation at any time.
To do so, activate "Alignment mode" in the "Settings" menu.
I N - H E LM E T I N STA L L AT I O N
EN
22