Technical Data; Before Starting The Equipment - Scheppach HMS1070 Traducción De Las Instrucciones Originales

6. Technical data

Technical data
Number of knives
Cutter block rpm
Dimensions
Weight
Technical data – Surfacing
Max planing width
Max chip removal
Ripping fence l x h
Ripping fence tilting
angle
Surfacing table size
Technical data – Thicknessing
Max planing width
Max planing thickness
Max chip removal
Thicknessing table size
Drive
Motor
Consumption power P1
Subject to technical changes!
Sound
Sound values were measured in accordance with EN
61029.
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Keep the noise emissions and vibrations to a
minimum!
• Only use appliances which are in perfect working
order.
• Service and clean the appliance regularly.
• Adapt your working style to suit the appliance.
• Do not overload the appliance.
• Have the appliance serviced whenever necessary.
• Switch the appliance off when it is not in use.
2 pieces
8500 1/min
970 x 490 x 485 mm
27 kg
254 mm
2 mm
635 x 127 mm
90°–135°
920 x 264 mm
254 mm
120 mm
2 mm
380 x 254 mm
230V / 50 Hz
1500 W
89 dB (A)
3 dB
102 dB (A)
3 dB
www.scheppach.com

7. Before starting the equipment

Before each use, check the following:
• Proper function of the on and off button, incl. the
emergency switch (if available).
• Locked disconnected protective equipment
(Fig. 1a - pos. 3)
by gradual opening of every separating protective
equipment to be able to turn the machine off and
checking that the machine cannot be turned on
whenever the protective equipment is open
• Brake
Switch on the machine at the start of work and al-
low the machine to reach speed. Now switch the
machine off again. The engine must come to a
standstill within 10 seconds. Otherwise, there is a
defect.
• Anti-kick claws (Fig. 4 - pos. 25)
at least once per shift by a visual inspection to
establish that they are in good working order, for
example, that the contact surface has not been
damaged by impacts and that the anti-kick claws
(25) fall back without hindrance due to their own
weight;
• Planing blades (Fig. 13 - pos. 24)
for signs of damage and to ensure they are posi-
tioned correctly.
The machine may only be used if all these condi-
tions are satisfied.
Use only well sharpened and maintained blades. Use
only blades that are designed for the machine.
Use pusher wood or sticks which are in perfect con-
dition for machining short workpieces.
Connect the machine to a dust and chip extractor.
Check that the stop is secure before starting the ma-
chining work.
Ensure that you can maintain your balance at all
times. Stand to the side of the machine.
Whilst the machine is running keep your hands at
a safe distance from the cutting block and from the
point at which the chips are discharged.
Do not start the planing work until the cutting block
has reached the required speed.
Also ensure that the workpiece does not contain any
cables, wires, cords or the like. Do not machine any
wood which has lots of knots or knot holes.
Secure long workpieces to prevent them tipping over
at the end of the planing process. Use roller stands,
for example, or similar devices for this purpose.
GB | 31