Metabo HPT C 3606DPA Instrucciones De Seguridad Y Manual De Instrucciones página 19

● Do not use any saw blades which do not conform
to the specifi ed rating.
Use only saw blades with a diameter according
to the markings on the saw.
● The saw blade must be suitable for the no-load
speed.
● Use a saw blade that is suitable for the material
being sawn.
● Use only genuine metabo HPT saw blades. Saw
blades intended for cutting wood or similar
materials have to conform to EN 847-1.
(13) Turn the lock lever anti-clockwise up to the stop while
holding the handle with one hand. The motor section
swings upwards.
CAUTION
Never touch the saw blade immediately after use.
The metal is hot and can easily burn your skin.
3. Check for proper operation of the brake
This power tool features an electric brake that
functions when the switch is released. Before using
the power tool ensure that the electric brake functions
properly. If it does not, bring the tool to a metabo HPT
AUTHORIZED SERVICE CENTER.
4. Prepare a wooden work bench (Fig. 15)
Since the saw blade will extend beyond the lower
surface of the lumber, place the lumber on a work
bench when cutting. If a square block is utilized
as a work bench, select level ground to ensure it is
properly stabilized. An unstable work bench will result
in hazardous operation.
Lumber
Work bench
CAUTION
To avoid possible accident, always ensure that
the portion of lumber remaining after cutting is
securely anchored or held in position.
WARNING
Operating the tool without wearing proper eye
protection may result in serious injury.
Base
Saw blade
Fig. 15
5. Check battery insertion
WARNING
If the battery is inserted while the power switch
is in the ON position, the power tool will start
operating immediately, inviting serious accident.
CAUTION
Until the battery locks in place with a little click,
if not, it may accidentally fall out of the tool
causing injury to you or someone around you.
ADJUSTSING THE SAW PRIOR TO USE
WARNING
To avoid serious accidents, ensure the switch is
in OFF position, and pull out the battery.
1. Setting cutting depth
It is advisable to set the depth of cut in such a way that
no more than half of each tooth on the saw blade juts
out under the workpiece. (Fig. 16)
<Adjustment in mm steps>
Press the locking button and move. Read off the set
cutting depth at the read-off edge.
(When the guide rail "GR" is used, read off at the "GR"
read-off edge.)
Release the locking button again. (Fig. 17)
Read-off edge of
guide rail "GR"
Locking button
<Precise adjustment (for extremely precise cutting depth
adjustment)>
The cutting depth can be set extremely precisely by
turning the adjuster.
Determine the exact cutting depth by measuring the
projecting saw blade or check the result by a trial cut.
English
1/1
1/2
Fig. 16
Read-off edge
Fig. 17
19