HIGH ONE 10S49 E W701T Instrucciones De Uso página 18

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

C
Useful information
Spray arms
Make sure that the spray holes are not clogged and that no food waste or foreign object is
stuck to the spray arms. If there is any clogging,remove the spray arms and clean them
under water. To remove the upper spray arm undo the nut holding it in position by turning
it clockwise and pulling it downwards. Make sure that the nut is properly tightened when
refitting the upperspray arm.
Drain Pump
Large food residues or foreign objects which were not captured by the filters may block the
waste water pump. The rinsing water will then be above the filter.
WARNING RISK OF CUTS!
When cleaning the waste water pump, ensure that you do
not injure yourself on pieces of broken glass or pointed
implements.
In this case:
1. First always disconnect the appliance from the power supply.
2. Take out baskets.
3. Remove the filters.
4. Scoop out water, use a sponge if required.
5. Check the area and remove any foreign objects.
6. Install filters.
7. Re-insert baskets.
32
EN
C
Useful information
Troubleshooting
Fault
Possible cause
Your Dishwasher is not
plugged in.
Your Dishwasher is not
switched on.
Fuse blown.
The programme does not
Water inlet tap is closed.
start.
Your Dishwasher door is
open.
Water inlet hose and
machine filters are clogged.
Water drain hose is clogged
or twisted.
Water remains inside the
The filters are clogged.
machine.
The programme is not
finished yet.
Power failure.
Machine stops during
washing.
Water inlet failure.
Shaking and hitting noises
The spray arm is hitting the
are heard during a wash
dishes in the lower basket.
operation.
33
Troubleshooting
Plug your Dishwasher in.
Switch your Dishwasher
on by pressing the On/Off
button.
Check your indoor fuses.
Turn on the water inlet tap.
Close the Dishwasher door.
Check the water inlet hose
and machine filters and
make sure they are not
clogged.
Check the drain hose, then
either clean or untwist it.
Clean the filters.
Wait until the programme is
finished.
Check mains power.
Check water tap.
Move or remove items
blocking the spray arm.
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

972914

Tabla de contenido