HIGH ONE 10S49 E W701T Instrucciones De Uso página 5

B
Using the appliance
NOTE PRINTING ON THE WATER INLET HOSE!
If models are marked with 25°, the water temperature may
be max. 25 °C (cold water).
For all other models:
Cold water preferred; hot water max. temperature 60 °C.
Water inlet hose
WARNING
• Use the new water inlet hose supplied with your machine,
do not use an old machine's hose.
• Run water through the new hose before connecting.
• Connect the hose directly to the water inlet tap. The
pressure supplied by the tap should be a minimum of
0.03 MPa and a maximum of 1 MPa. If the pressure exceeds
1 MPa, a pressure relief valve must be fitted between the
connection.
6 EN
B
Using the appliance
WARNING
• After the connections are made, turn the tap on fully and
check for water leaks. Always turn off the water inlet tap
after a wash program has finished.
WARNING
An Aquastop water spout is available with some models.
Do not damage it or allow it to become kinked or twisted.
Drain Hose
Connect the water drain hose directly to water drain hole or to the sink outlet spigot. This
connection should be minimum 50 cm and maximum 110 cm from flor plane.
IMPORTANT
Items will not wash properly if a drain hose longer than
4 m is used.
min 4cm
7 EN