Contraindication; Attentions; Unpacking And Inspection - MedLinket AM801 Manual Del Usuario

Present SpO2 oximeter transmits light of two wavelengths only, red light and
infrared, to differentiate HbO2 from HbR. One side of the sensor contains two LEDs,
and the other side contains a photoelectric detector. SpO2 oximeter measures HbO2
saturation in the blood by the light plethysmograph when the pulse beats. The
result is quite precise when HbO2 saturatiion is between 70% to 100%.
Regarding temperature measurement, it's based on the principle that resistance of
thermistor based on the metal conductor increases with temperature decrease, and
changes linearly with the temperature measurement characteristics.

Contraindication

The device can not be used for patients with diseases or conditions including blood
microcirculation disorder, excessive staining in the blood, disorders of important
hemoglobin indicators and severe arrhythmia.

Attentions

● Keep the oximeter away from dust, vibration, corrosive substances, explosive
materials, high temperature and moisture.
● If the oximeter gets wet, please stop using.
● When it is carried from cold environment to warm and humid environment,
please do not use it immediately.
● DO NOT operate keys on front panel with sharp materials.
● High temperature or high pressure steam disinfection of the oximeter is not
permitted. Refer to User's Manual for instructions of cleaning and disinfection.
● Do not have the oximeter immerged in liquid. When it needs cleaning, please
wipe its surface with disinfect solution by soft material. Do not spray any liquid on
the device directly.
● When cleaning the device with water, the temperature should be less than 60℃.
● Temperature probe that is compatible with pulse oximeter mentioned in this IFU
include W0024E.
● The operator is responsible for checking the compatibility of the equipment
connected,probe cable extender and probe before use.
● Incompatible components can result in degraded performance.

Unpacking and Inspection

Remove the instrument of PULSE OXIMETER from the shipping carton and
examine for signs of shipping damage. Please check all materials against the
packing list. Save the invoice, bill of lading and all packing materials. These may
be required if it is necessary to process a claim with the carrier.
If anything is missing or damaged, please contact the Technical Service
Department.
You can contact by:
● Phone: +86 755 61120085
● Fax: +86 755 61120055
● Email: user07@med-linket.com
English 10