Foreword; Warning - MedLinket AM801 Manual Del Usuario

The Pulse Oximeter manual is intended to provide information for proper operation
and maintenance. General knowledge of monitoring and understanding of the
features and functions of the Pulse Oximeter are prerequisites for proper use. Please
read these instructions carefully before using this equipment.
The manual describing the operating procedures should be followed strictly. Failure
to follow these instructions can cause measuring abnormality, equipment damage
and personal injury. The manufacturer is NOT responsible for the safety, reliability
and performance issues and any monitoring abnormality, personal injury and
equipment damage due to user's negligence of the operation instructions.
The Pulse Oximeter is a medical device, and can be used repeatedly.
Warnings are identified by the WARNING symbol shown above.
● Explosion hazard. Do not use the PULSE OXIMETER in the presence of flammable
anesthetics mixed with air, or with oxygen, or nitrous oxide.
● Do not spray, pour, or spill any liquid on the PULSE OXIMETER and its accessories.
● Reusable sensors must be moved to a new site at least every 4 hours. Because
individual skin condition affects the ability of the skin to tolerate sensor placement,
it may be necessary to change the sensor site more frequently with some patients. If
skin integrity changes, move the sensor to another site.
● At elevated ambient temperatures, patient skin could be severely burned after
prolonged sensor application at sites that are not well perfused. To prevent this , be
sure to check patient application sites frequently. The temperature of the sensor
contacting with skin won't exceed 41℃ if the initial skin temperature doesn't exceed
35℃.
● Be aware that following removal of the sensor from the patient, it is possible that
environmental light may cause the oximeter to continue to display a waveform or
data values but these data should not be used as a basis for a clinical diagnosis.
● Portable and mobile RF communications equipment can affect MEDICAL ELECTRI-
CAL
EQUIPMENT.
● The waste of PULSE OXIMETER must not be disposed as unsorted municipal waste
and must be collected separately. Please contact an authorized representative of the
manufacturer for information concerning the disposal of your equipment.
● This device is not intended for treatment.
● The LCD panel contains toxic chemicals. Do not ingest chemicals from a broken LCD
panel.
● Do not modify this equipment without authorization of the manufacturer.
● Don't reuse disposable temperature probe or it may cause cross-infection among
patients.

Foreword

Warning

English 4