Setting Of Release Valve - Manutan A369872 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62

3. SETTING OF RELEASE VALVE

On the handle of this hand pallet truck, you can find a lever, which operates in three positions:
Lower - Lowering the fork - LOWER-Position
Drive - Drive the truck - Drive-Position
Raise - Lift the fork - WWRaise-Position
All hand pallet trucks are checked and already fit for the releasing function. However if they have been
changed, you can adjust according to the following steps
3.1 If the forks elevate while pumping in the DRIVE position, turn the adjusting nut (Part No. 59) on
the adjusting bolt (Part No. 58) clockwise until pumping action does not raise the forks and the DRIVE
position properly.
3.2 If the forks descend while pumping in the DRIVE position, turn the nut (Part No. 59) counter-clo-
ckwise until the forks stops going down.
3.3 If the forks do not go down when the Lever is in the LOWER position, turn the nut (Part No. 59) clo-
ckwise until raising the Lever (Part No. 51) lowers the forks. Then check the DRIVE position according
to item 3.1 and 3.2 to be sure that the nut (Part No. 59) is in the proper position.
3.4 If the forks do not elevate while pumping in RAISE position, turn the nut (Part No. 59) counter-clo-
ckwise until the forks elevate while pumping in the RAISE position. Then check the LOWER and DRIVE
positions according to item 3.1, 3.2 and 3.3 .
Pict 2
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

A369875

Tabla de contenido