Fault Diagnosis, Examination, Disposal - Manutan A369872 Manual Del Usuario

6.4 Do not use the pallet truck on a uneven or slopping ground. Do not use the pallet truck on gra-
dients.
6.5 The pallet truck is not allowed to be used in insufficiently illuminated areas. Minimum illimination
must be at least 50 lux.
6.6 If the pallet truck is moving, it is not allowed to turn the handle into the right angle to stop the
pallet truck.
6.7 It is forbidden to use hand pallet truck for people transportation.
6.8 It is not allowed to use the pallet truck as a jack.
6.9 It is not allowed to use the fork of the pallet truck as a lever to lift loads.
6.10 Do not load like the picture 3.B.
6.11 Do not load over maximum capacity.
6.12 It is not allowed to use the pallet truck in risky conditions.
6.13 It is not allowed to use the pallet truck in direct contact with food.
6.14 It is not allowed to use the pallet truck in explosive atmosphere.
6.15 Operator must wear safety boots and gloves.
6.16 Whilst the goods are being transported all none operational staff should be at a minimum dis-
tance of 600mm.
6.17 At service work, it is not allowed to scatter parts.
6.18 Under any special conditions or environments, the operator should carry out all relevant risk
assessments and method statements before commencing work with the pallet truck.
6.19 It is forbidden to use the pallet truck if there is a risk that the pallet truck and load may fall down,
for example, from unsecured ramps.

7. FAULT DIAGNOSIS, EXAMINATION, DISPOSAL

No. Trouble
The forks cannot be up at
1
the max height
The fork cannot be lifted
2
up
The forks cannot be
3
descended
4 Leaks
Cause
The hydraulic oil is not enough
-Without hydraulic oil
- The oil has impurities
- The nut (Part No. 59) is too high,
keep the pumping valve open.
- The air comes into the hydraulic oil
-The piston rod (Part No. 9)
or pump body (Part No. 15) is
deformed resulting from partial
loading slanting to one side or
over loading.
- The fork was kept in the high
position for long time with pis-
ton rod bared to arise in rusting
and jamming of the rod.
- Adjusting the nut (Part No. 59)
is not the correct position.
- Sealing parts worn or damaged.
- Some parts creaks or worn out
8
Fixing Methods
Pour in the oil
- Fill in the oil
- Change the oil
- Adjust the nut (Part No.59)
(see item 3.4)
- Bannish the air (see item 5.2)
- Replace the piston rod (Part
No. 9) or the pump body (Part
No. 15)
- Keep the fork in the lowest
position if not using, and pay
more attention to lubricate
the rod.
- Adjust the nut (Part No.59)
(see the item 3.3)
- Replace with the new one.
- Replace with the new one.