Fcc Warning; Installation Instructions - Blaupunkt San Andres 970 Manual De Usuario

used unless the interference is disappeared;

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:

(1) this device may not cause harmful interference,

(2) this device must accept any interference received, including interference that may cause undesired,ope

ration.

Installation Instructions


The vehicle must meet the voltage, current and power that required, please check the conditions before

installation;

The installation should be done while the battery of the vehicle is disconnected;

To ensure that the product has been fitted with a fuse;

The installation of the product should not affect the safety of the operation and function of the

vehicle;

The installation position should not block the driver's sight and should not be on the place that the brake,
steering wheel, seat belts, airbags and other vehicle safety equipment should be;

Please confirm the matching condition of the vehicle interface before install this product, use the
appropriate patch plug if the interface is not matched;

Please be familiar with the connection of the vehicle before installation, confirm the position of the
piping, electrical wiring, fuel tank and other vehicle system components. Do not touch or damage these
components and avoid the exposure of wires that may cause corrosion, leakage, etc.;

Please do not conduct the installation in place of condensation, drench water sites, high humidity,
containing dust and oil smoke. If water, moisture, dust and oil smoke enter the product, it may cause smoke,

fire or failure;

Please do not move or disassembled the existing screws, nuts, bolts, clips, connecting fixed appliances,
accessories and so on, do not change or remove vehicle incidental contact system and wire clip, otherwise it
may impair the function of automobile safety;

In order to avoid the occurrence of fire damage to the product or vehicle, please do not allow the
existing power supply circuit overload when power the product; Please be sure that the power wires have
insulation treatment and install with fuses, circuit breakers and relays;

Please use non conductive tape in insulation treatment, wrap the ends of the wire and unused wire; correct
insulating treatment can avoid the occurrence of electric arc, electric shock or fire. In order not to impede the
brake pedal, gearbox and steering wheel, plastic belt could be used to fix the wires. Please do not make the
wires contact high temperature surface, the heat can easily cause damage to the wires and lead to short circuit,

arc or fire;

Please fix the wire on the electric chair or other parts of vehicle where will not lead to the scratch or
damage of wire. In addition, the wire should be fixed in the hidden place as far as possible, it will make
the environment inside the vehicle beautiful;

Please do not block the airflow vents, otherwise it may cause internal overheat and fire;

After the installation is completed, please check the wire connection of the vehicle, then run all functions,
including lights, speakers, stereo, reversing operation and other electrical systems and ensure that the vehicle
function is normal and can be used safely.






4




