Initial Configuration; Connection To An External Timer Thermostat - Palazzetti EASY TOUCH Uso Y Funciones

1 INITIAL CONFIGURATION

Depending on the type of installation, the best con昀椀guration needs to be selected for the stove operation.
Before proceeding, power up the stove using the safety switch on the rear.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the
d) Press and enter the value "54" using the
to con昀椀rm;
e) Press
f) The current con昀椀guration will be displayed;
g) To change the con昀椀guration, press
to con昀椀rm.
h) Press
After having changed the con昀椀guration a communication error message may be displayed for a few
seconds. Ignore this and switch the stove o昀昀 using the safety switch on the rear, wait a few seconds and
switch it back on.
TWO DIFFERENT CONFIGURATIONS ARE AVAILABLE:
CONFIGURATION 1 (default)
Set this con昀椀guration to switch the stove on or o昀昀 manually or in programmed mode.
The stove will module its power according to the room temperature read by the probe on the stove.
It is possible to set the function "Eco-mode" to allow the stove switch on or o昀昀 according to the set
temperature.
In this con昀椀guration it is possible to set also the antifreeze function.
CONFIGURATION 2
Set this con昀椀guration when the stove is controlled by an external thermostat (or timer thermostat).
In this con昀椀guration the stove switches o昀昀 when reaching the external thermostat setting.
In this con昀椀guration it is not possible to set also the antifreeze function.

1.1 CONNECTION TO AN EXTERNAL TIMER THERMOSTAT

The stove can be connected to an external timer thermostat that switches the stove on or o昀昀 according to the
set temperature.
When the set temperature is reached the thermostat opens the circuit and consequently switches o昀昀 the stove.
The external thermostat is connected to the two terminals on the board of the stove, which are jumpered in the
factory. Disconnect the jumper and connect the two thermostat contacts.
The stove must be set to con昀椀guration 2 following the instructions shown in the paragraph on "Initial con昀椀guration".
After 昀椀rst installing the timer thermostat, the stove needs to be switched on manually, while the timer thermostat is
in "call" status. This operation is also required in the event of power failures or if the stove is switched o昀昀 manually.
To avoid overlapping the working time bands, it's recommend to disable (set to OFF) the stove's timer.
to go to the setup menu
buttons to scroll to and select submenu
and enter the value of the new con昀椀guration using the
004776500 - 11/12/2019
and then press ;
to con昀椀rm;
" will 昀氀ash on the display;
[30] --0
; "
buttons;
buttons;
17