Initial Settings - Palazzetti BLE Manual De Uso Y Funciones

1

INITIAL SETTINGS

Depending on the type of installation, the stove must be set according to the most correct configuration
for its operation. Before starting, the stove must be powered on by pressing the safety switch on the back:
a) Use the arrow keys
b) Select the password "7" with the
c) Scroll with the keys
d) Press the key and enter the value "54" with the
e) Press to confirm;
f) The configuration currently in use will be displayed;
g) To modify, press the
h) Press to confirm.
After changing the configuration, a communication error message may appear for a few sec-
onds. Ignore it and switch the stove off with the safety switch on the back, wait a few seconds
and switch it on again.
1.1 Configuration selection
1.1.1 CONFIGURATION 1 (default)
Set this configuration to switch the stove on and off manually or with a program.
The stove will modulate the power according to the ambient temperature read by the probe on board.
It is possible to set the "Eco-mode" function so that the stove switches off or on again according to the set
room temperature.
In this configuration it is also possible to set the anti-freeze function, which will work with the timer
enabled.
1.1.2 CONFIGURATION 2
Set this configuration when the stove is controlled by a room thermostat (or chronothermostat)(Fig. 1 - A).
In this configuration the stove switches off when the room thermostat is satisfied.
The antifreeze function cannot be set in this configuration either.
The connector terminals are located on the back of the stove.
The first time, following the installation of the chronothermostat, the stove must be switched
o
manually while the chronothermostat is in the "called" state. This operation is also necessary
in the event of a power failure or if the stove is switched off manually.
To avoid
the stove timer (set to OFF).
20
to go to the set-up menu
key and confirm with the
and select the submenu
key and enter the value of the new configuration with the
overlapping operating
and press the key;
key;
[30] --0
; will flash "
keys;
time bands, we
";
keys;
recommend disabling
004778040 - 07/10/2020
n