Eco Mode" Saving Function; Restart Delta Function; Restarting After A Power Failure; Lock Keypad" Function - Palazzetti EASY TOUCH Uso Y Funciones

5.2 "ECO MODE" SAVING FUNCTION

Enabling this function means that the stove switches o昀昀 when reaching the desired room temperature. If this
function is not enabled, the stove modulates operation so as to maintain the desired temperature while consuming
the least amount of fuel possible. The "Eco Mode" function is only available in con昀椀guration 1.
To enable/disable the function:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) Set one of the following values using the
→ "Eco Mode" function enabled
Eco
→ "Eco Mode" function disabled
Off
to con昀椀rm the settings.
e) Press

5.3 RESTART DELTA FUNCTION

The Restart delta is the number of degrees centigrade below the switch-o昀昀 temperature at which the stove
switches on again automatically. For example, if the stove is set to switch o昀昀 at 20°C (Eco Mode active) and
"Restart delta" is set to 4°C, the stove will switch on again when the temperature measured is less than or equal
to 16°C.
To set the restart delta value:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) The value will 昀氀ash; change it using the
button to con昀椀rm the set value.
e) Press the

5.4 RESTARTING AFTER A POWER FAILURE

In the event of power failures, the stove will switch back on automatically, checking the safety conditions, when
power returns.

5.5 "LOCK KEYPAD" FUNCTION

This function is used to disable the use of the control panel and avoid accidental modi昀椀cations.
To enable/disable the function:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) Use the
" " Lock keypad disabled
Off
"Lo" Only the on/o昀昀 button
" " Lock keypad enabled
Hi
to con昀椀rm the settings.
e) Press

5.6 FROST PROTECTION FUNCTION

(Only in con昀椀guration 1)
A minimum temperature can be set below which the stove will switch on (outside of the set time bands, and only
if the timer is active). To set the "frost protection" temperature:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Select submenu
d) The value will 昀氀ash; change it using the
to con昀椀rm the settings.
e) Press
to go to the setup menu
and con昀椀rm by pressing
[7]
to go to the setup menu
[8] to con昀椀rm;
and press
to go to the setup menu
and con昀椀rm by pressing
[10]
buttons to set one of the following values:
is enabled
to go to the setup menu
[9] and con昀椀rm by pressing
004776500 - 11/12/2019
and then press
to con昀椀rm;
.
buttons:
and then press
to con昀椀rm;;
buttons (
0,5 ... 5,0°C
and
and then press
to con昀椀rm;
.
and then press
to con昀椀rm;
;
buttons (
OFF 3...20°C
;
;
;
);
;
;
);
25