Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 "ECO MODE" SAVING FUNCTION
Enabling this function means that the stove switches off when reaching the desired room temperature. If this function is
not enabled, the stove modulates operation so as to maintain the desired temperature while consuming the least amount
of fuel possible. The "Eco Mode" function is only available in configuration 2.
To enable/disable the function:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c)
Select submenu
d)
Set one of the following values using the
→ "Eco Mode" function enabled
Eco
→ "Eco Mode" function disabled
Off
e)
Press
to confirm the settings.
5.3 RESTARTING AFTER A POWER FAILURE
In the event of power failures, the stove will switch back on automatically, checking the safety conditions, when power
returns.
5.4 "LOCK KEYPAD" FUNCTION
This function is used to disable the use of the control panel and avoid accidental modifications.
To enable/disable the function:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
and confirm by pressing
[10]
d) Use the
buttons to set one of the following values:
"
" Lock keypad disabled
Off
"Lo" Only the on/off button
"
"
Lock keypad enabled
Hi
e) Press
to confirm the settings.
5.5 FROST PROTECTION FUNCTION
In configurations 2, 3 and 4 a minimum temperature can be set below which the boiler will switch on (outside of the set
time bands).
CONFIGURATION 2:
To set the "frost protection" temperature:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
and confirm by pressing
[9]
d) The value will flash; change it using the
e) Press
to confirm the settings.
CONFIGURATION 3 AND 4:
To set the "frost protection" temperature:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
and confirm by pressing
[9]
d) The value will flash; change it using the
e) Press
to confirm the settings.
Setting the value to "OFF" in step d disables the function.
26
to go to the setup menu
and confirm by pressing
[7]
to go to the setup menu
is enabled
to go to the setup menu
buttons (
to go to the setup menu
buttons (
and then press
to confirm;
.
buttons:
and then press
to confirm;
.
and then press
to confirm;
;
;
°C);
OFF
3...20
and then press
to confirm;
;
;
°C);
OFF
3...50
;
;
;
;
004778911 - 26/01/2022
Publicidad
Tabla de contenido
