Cutting Angle Adjustment - Truper MAX-20SC Manual

Cutting angle adjustment

• Loosen the cutting angle adjustment knobs (D).
• With the base stationary, rotate the housing until the blade is at the desired angle.
• Tighten the cutting angle adjustment knobs to prevent the housing from moving during cutting.
• The tool can make cuts from 0° to 45°.
• The cutting line marked on the graduated scale on the base (E) changes depending on the angle set.
Cutting line adjustment
• To keep the width of the workpiece fixed when making cuts,
use the cutting guide.
• To adjust the width, loosen the knob (E) and move the
cutting guide to the desired position.
• This action improves the quality of the cut and reduces the
possibility of deformation of the cut-off disc.
10
ENGLISH
Cutting
line at 0°
D
Start up
E
Cutting
line at 45°
E