Mem Key; Auto Power Off Function - HT HT2236 Manual De Instrucciones

4.2.3. MEM key

Press the MEM key to save measurement results. Up to 40 memory locations are
available in order to save 10 instantaneous values, 10 maximum values (MAX), 10
minimum values (MIN) and 10 average values (AVG) starting from the sample values
continuously detected by the instrument. Data saved in the same location
"DATA0...DATA9" always overwrite the old values.
To save a measurement result, proceed as follows:
1. Press and hold the
2. With the /MEAS key pressed, press the MEM key;
3. The instantaneous, maximum, minimum and average values are saved in the memory
location active on the display and the location number will be automatically increased.
To recall a saved result, proceed as follows:
1. Cyclically press the MEM key with the instrument in HOLD condition;
2. The instantaneous, maximum, minimum and average values of saved data are shown
on the display and then the instrument goes to the next memory location;
3. Press and hold the MEM key to quickly select the desired memory location bypassing
the cyclical phase of the saved values.

4.2.4. Auto Power OFF function

The instrument automatically switches off after approx 15 seconds after the
has been released (HOLD function).
/MEAS key to start measuring;
EN - 5
HT2236
/MEAS key