Speed Measurement On A Mobile Surface - HT HT2236 Manual De Instrucciones

5.3.

SPEED MEASUREMENT ON A MOBILE SURFACE

1. Fit the the mechanical adapter (see Fig. 1 – part 1) onto the instrument and use the
extension sleeve, if necessary (see Fig. 1 – part 2).
2. Insert the standard rubber wheel onto the mechanical adapter.
3. Turn on the instrument by pressing the
4. Press the MODE key and select "rPM, HZ, M/M, I/M, F/M or Y/M" modes at display
depending on the type of measurement (see § 4.2.2).
5. Press the MODE key and select "REV, M, In, FT or Yd" modes at display to perform
length measurement (see § 4.2.2).
6. Press and hold the
to be measured (see Fig. 4) and perform the measurement.
7. Press the MEM key to save the measured result (see § 4.2.3).
/MEAS key, placing the rubber wheel on the surface of the object
Fig. 4: Speed measurement on surfaces
EN - 8
/MEAS key.
HT2236