Installation; Unpack The Machine; Install The Spray Wand; Install The High Pressure Hose - GreenWorks GDC40 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Separate collection of used machine and
packaging let you recycle materials and use
them again. Use of the recycled materials
helps prevent environmental pollution and
decreases the requirements for raw materi-
als.
At the end of their useful life, discard batter-
ies with a precaution for our environment.
The battery contains material that is danger-
ous to you and the environment. You must
remove and discard these materials separate-
ly at a equipment that accepts lithium-ion
batteries.
7

INSTALLATION

7.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine before
use.
WARNING
If the parts have damage, do not use the machine.
If you do not have all the parts, do not operate the
machine.
If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
7.2

INSTALL THE SPRAY WAND

8
14
1. Push the end of the spray wand (8) into the gun handle.
2. Turn the spray wand (8) clockwise until the tabs lock into
position.
English
9
10
WARNING
Make sure that the connection has no leakage.
7.3
INSTALL THE HIGH PRESSURE
HOSE
13
11
1. Push one end of the high pressure hose (11) into the inlet
coupler (13).
2. Install and tighten the other end of the high pressure hose
(11) onto the water outlet coupler.
7.4
CONNECT THE WATER SUPPLY
TO THE MACHINE
The machine works only when there is water in the bucket or
the base is connected with a water supply. When there is no
water connected, push the power switch to stop the machine.
7.4.1
CONNECT THE WATER SUPPLY TO
THE MACHINE
WARNING
The water supply must come from the water main
Do not use hot water
Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
CAUTION
Inspect the filter in the water inlet connector before you
connect the garden hose
If the filter is damaged, do not use the machine until the
filter is replaced.
If the filter is dirty, clean the filter.
7
EN
11

Publicidad

Tabla de contenido
loading

Tabla de contenido