Truper MOTO-AI Manual De Instrucciones página 6

Safety warnings for
rotary tools
Charging the Rotary Tool
• Misusing the charger may cause damages.
• Regularly check the charger is not damaged, especially
the connector cable and the housing.
• Do not use the charger if it was submitted to knocks or
discharge. Go to a Authorized Service
Center to repair before using it.
• For no reason at all disassemble the charger. Repairs
shall only be carried out by
Authorized Service Center staff. Improper assembly may
cause fire or electric shock.
• Never use the charger in places where explosive or
flammable materials are present.
• Connect the charger only to household power outlet. Do
not connect the charger if the power outlet has a different
voltage tension different to the one indicated in the
specifications label.
• A faulty electric installation or excessive tension in the
power outlet may originate an electric discharge.
• Connect the charger into a power outlet with easy access
to be able to disconnect quickly in case of fault.
• Not charging the rotary tool correctly may damage the
battery, the charger and the rotary tool.
• Charge the rotary tool in a 32 °F to 113 °F environment.
Ideal environment temperature is 73 °F
• Double check the ventilation is adequate when charging
the batteries. In this process gases are released.
• Charge the rotary tool inside. Do not charge outdoors.
• Check the charger is not in humid environment.
Otherwise there is risk of electric shock.
• Do not use the rotary tool for purposes different from its
designed. The charger is only built to charge the rotary
tool. Different uses may result in fire or
fatal electric shock.
• Do not try to charge the rotary tool with a charger that is
different from the one supplied.
• Use the charger only to charge the rotary tool and not as
power supply while operating the rotary tool.
• Do not set object onto the charger. Do not cover,
because it overheats. Never set it close to heat sources.
• Set the power cable in a way that nobody will trip with it
or step on it.
• After charging the rotary tool always disconnect the
charger from the power supply.
• Never pull or disconnect the charger using the
connection cable.
• Preferably, avoid using extension cables. If absolutely
necessary using an extension cable double check the
electric requirement mentioned in page 3 are observed.
• Never set the rotary tool or the accessories onto o near
hot surfaces.
6
ENGLISH