Start Up; Installing Accessories - Truper MOTO-AI Manual De Instrucciones

Rotary Tool Battery Charging
•Charge the rotary tool it is completely discharged; the sample
turns on and off rapidly without generating any load.
• When using an Ion-Lithium rechargeable battery, the rotary
tool may be charge at any moment no matter the charge level
and with no capacitance loss.
• The rotary tool has low battery charge when purchased. It
shall be charged before the first use:
1. Insert the cable contact plug (b) in the rotary tool battery
charge connection (c).
2. Plug the charger plug into a 127V~ outlet. The LED
indicator (a) should turn red, indicating that charging has
started. When the battery is fully charged, the red light will
turn green.
3. Disconnect the charger from the power outlet after charging
is complete.
4. Remove the charger cable from rotary tool battery charge
connection.
5. Give the rotary tool time to cool down in environment
temperature if getting hot during the charge process. You can
now operate the rotary tool.
If the green light stays on, it is a sign of the following
conditions:
1. The battery temperature is lower than 0 °C or higher than
45 °C; please wait until the battery temperature is in the
proper range to be able to charge.
2. The battery or the tool is defective; you must go to a
Authorized Service Center.

Installing accessories

• Un-plug the rotary tool.
1. Insert a jaw (A) of the desired gauge for the axis
accessory into the rotary tool axis (B).
2. Depress the shaft lock (C) while threading but not
tightening the jaws chuck (D).
3. Insert he accessory (E) you need into the jaws. Never
try to force entry of the accessory. Better, change the jaws
and use a larger caliber.
4. Pressing the shaft lock use a collet wrench to tighten
the collet chuck and have the collet securing the
accessory. Verify the accessory is not loose in the
tightened jaws. In which case, change it for a
lower caliber.
• To remove the accessory, press the shaft lock while
loosening the collet.
WARNING
• Do not press the shaft lock while the
tool is running.
8
ENGLISH

Start Up

c
b
a
1
A
B
2
C
D
3
E
4