To Put The Cutting Deck In Mow Position; To Do A Check Of The Parallelism Of The Cutting Deck; To Adjust The Parallelism Of The Cutting Deck - Husqvarna R 418TsX AWD Manual De Usuario

To put the cutting deck in mow position

1. Hold the front edge of the cutting deck (A) with one
hand. Push the cutting deck in the direction of the
product.
2. Pull the lock handle (B) with your other hand to
disengage the locked position of the cutting deck.
B
3. Fold down the cutting deck (C) until it is level to the
ground.
4. Pull the lock handle and push the cutting deck in the
direction of the product until it stops.
5. Push down the lock handle.
To do a check of the parallelism of the
cutting deck
1. Make sure that the air pressure in the tires is correct.
Technical data on page 129 .
Refer to
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the servicing position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 4–6 mm (1/5") higher than the
front edge.
To adjust the parallelism of the cutting
deck
1. Park the product on hard level ground.
2. Apply the parking brake.
880 - 009 - 31.10.2022
3. Move the weight transfer lever down.
A
4. Move the lift lever rearward and lift the cutting deck
C
5. Move the lift lever forward and lower the cutting deck
6. Set the cutting height lever to the servicing position.
7. Remove the clevis joint on the front end of the height
to the transport position to engage the lift support.
to the mow position.
adjustment stay. Move the height adjustment stay to
the side.
117