To Remove The Jumper Cables; Tire Pressure; To Put The Cutting Deck In Mow Position; To Put The Cutting Deck In Servicing Position - Husqvarna R 316TX Manual De Usuario

To remove the jumper cables

Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.

Tire pressure

The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.
To put the cutting deck in servicing
position
To remove the cutting deck on
1. See steps 1–8 in
page 13 .
2. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
844 - 009 - 25.11.2021
3. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.

To put the cutting deck in mow position

1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
CAUTION:
caught below the cutting deck. Pull on
the drive belt loop in the belt holder
before you push the cutting deck in.
4. Lift the cutting height stay from the stay holder and
put it in the hole.
The drive belt can get
25