To Remove The Covers - Husqvarna R 418TsX AWD Manual De Usuario

To clean the cold air intake of the engine
WARNING:
air intake rotates and can cause injury to
your fingers.
1. Make sure that the grille for the cold air intake on the
engine cover is not blocked. Remove grass and dirt
with a brush.
2. Open the engine cover.
3. Make sure that the engine cold air intake is not
blocked. Remove grass and dirt with a brush.
4. Examine the air duct, found on the inner surface of
the engine cover. Make sure that the air duct is clean
and does not rub against the cold air intake.

To remove the covers

To remove and install the engine cover
1. Fold the seat forward.
112
Stop the engine. The cold
2. Release the 2 clips on the engine cover with the tool
attached to the ignition key.
3. Remove the screws from the hinges.
4. Fold the engine cover rearward.
5. Install in opposite sequence.
To remove and install the front cover of the
cutting deck
1. Remove the cutting deck. Refer to
cutting deck on page 105 .
2. Remove the 2 screws and remove the front cover of
the cutting deck.
3. Install in opposite sequence.
To remove and install the side cover of the
cutting deck
1. Remove the cutting deck. Refer to
cutting deck on page 105 .
To remove the
To remove the
880 - 009 - 31.10.2022