Tire Pressure; To Put The Cutting Deck In Servicing Position; To Put The Cutting Deck In Mow Position - Husqvarna Rider 318 Manual De Usuario

Tire pressure

The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.
To put the cutting deck in servicing
position
To remove the cutting deck on page
1. See step 1–8 in
11 .
2. Hold the front edge of the cutting deck with two
hands and pull forward until it stops.
3. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.

To put the cutting deck in mow position

1. Hold the front edge of the cutting deck with your left
hand.
246 - 001 - 04.10.2017
2. Loosen the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
CAUTION: The drive belt can get caught
below the cutting deck. Pull on the drive
belt loop in the belt holder before you
push the cutting deck in.
4. Lift the cutting height stay from the stay holder and
put it in the hole.
5. Put the drive belt around the drive wheels. Make
sure that the drive belt is on the correct side of the
tension wheel.
6. Put the spring in the spring holder.
7. Attach the front cover.
8. Set the cutting height lever in one of the positions 1–
10.
21