Battery - ROTOR INspider ROT117 Manual De Usuario

6. BATTERY

6.1. INSTALLATION AND SPECIFICATIONS
ROTOR INspider is powered by
Estimated riding time:
When battery level is lower than 3.5 V, the computer device will show a "low battery" message. From
that moment, estimated riding time is 30 hours, and recharging is recommended. A complete charging
cycle takes approximately 4 hours in which the LED will blink until the battery is fully charged. The
battery's charge level can be checked with any computer or Bluetooth® Smart / ANT+ compatible
device.
Battery can be fully recharged at least 300 times without being damaged, so it shouldn't be necessary
to replace the battery during the life time of the power meter. A special tool is required in case battery
replacement is needed. For that purpose, contact your ROTOR dis tributor and they will assist you.
* Tests performed
User Software or the ROTOR Power app) is greater, reducing the hours of autonomous use.
6.2. BATTERY RECHARGING
6.2.1. Open the dust cover that protects the charging port. Do not use any tool or cutting object.
6.2.2. Connect the magnetic charger to the charging port in the spider. After that, connect the USB
terminal to a power source.
46 Battery
a Lithium (Li-ion) battery with 3.7 V of nominal tension.
220 hour . s*
in laboratory conditions. Fast mode consumption (only available when connected to the
TM