Battery; Battery Replacement - ROTOR INpower ROAD Manual De Usuario

6. BATTERY

6.1. INSTALLATION AND SPECIFICATIONS
ROTOR INpower is powered by one standard AA battery (not included). ®
Estimated riding time: 300 hour .
The battery must be installed correctly, with the positive "+"
facing outward, and should have enough charge for use. The
battery's charge level can be checked with any computer or
Bluetooth® Smart / ANT+ compatible device. The LED blinks
green while the power meter is active. After introducing the battery do not forget to place the contact
in its housing and turn it clockwise to ensure that the battery makes contact.
The battery cover consists of two sets: the contact set and the cover set. Both
when it is necessary to change the battery or when uninstalling the cranks. Repeated opening can
can damage the internal contacts and O-rings.
Do not extract any part from each of the sets.
All components must be assembled as shown right.
Be careful when turning the battery cover to
prevent any damage to the internal contacts and
the seal.
Tests performed with alkaline batteries from leading
brands. Consumption in fast mode (active only when
connected to the User Software running on a computer)
is greater, thus reducing the hours of autonomous use.

6.2. BATTERY REPLACEMENT

6.2.1. Open the cover set by turning it counterclockwise with an 8 mm allen wrench.
6.2.2. Turn the contact set counterclockwise until the two tabs are aligned with the two cavities that
allow its removal. Remove the contact set.
6.2.3. Remove the old battery from its housing. Do not use any sharp objects, the spring will expel the
battery.
6.2. . 4 Insert the new battery in its place, with the positive side facing toward the outside.
52 Battery
s*
TM
should only be removed
Cover set
Contact set