Whirlpool W6 OM4 4PBS1 P Guía De Consulta Diaria página 6

action to be done. Check the food, close the door and
press or to continue cooking.
Please note: Press to skip these actions. Otherwise, if no
action is done after a certain time the oven will continue the
cooking.
6. END OF COOKING
An audible signal will sound and the display will
indicate that cooking is complete.
END
Press to continue cooking in manual mode (untimed)
or press to extend the cooking time by setting a new
duration. In both cases, the cooking parameters will be
retained.
BROWNING
Some functions of the oven enable you to brown the
surface of the food by activating the grill once cooking
is complete.
PRESS v TO BROWN
When the display shows the relevant message, if
required press to start a five-minute browning cycle.
You can stop the function at any time by pressing
switch the oven off.
. FAVORITES
Once cooking is complete the display will prompt you
to save the function in a number between 1 and 10 on
your list of favorites.
ADD FAVORITE?
If you would like to save a function as a favorite and
store the current settings for future use, press
otherwise, to ignore the request press
Once has been pressed, press the
number position, then press
Please note: If the memory is full or the number chosen has
already been taken, the oven will ask you to confirm
overwriting the previous function.
To call up the functions you have saved at a later time,
press : The display will show your list of favorite
functions.
1. CONVENTIONAL
Press or to select the function, confirm by pressing
, and then press
6
.
or to select the
to confirm.
to activate.
. AUTOMATIC CLEANING – PYRO
Do not touch the oven during the Pyro cycle.
Keep children and animals away from the oven
during and after (until the room has finished airing)
running the Pyro cycle.
Remove all accessories - including shelf guides - from
the oven before activating the function. If the oven is
installed below a hob, make sure that all the burners
or electric hotplates are switched off while running
the selfcleaning cycle. For optimum cleaning results,
remove the worst soiling with a damp sponge before
using the Pyro function. We recommend only running
the Pyro function if the appliance contains heavy soiling
or gives off bad odours during cooking.
Press to show "Pyro" on the display.
Pyro
Press or to select the desired cycle, then press
to confirm. Once a cycle has been selected, if desired,
press or to set end time (start delay), then press
to confirm.
Clean the door and remove all accessories as prompted,
then close the door and press
will begin the self-cleaning cycle, while the door locks
to automatically: a warning message appears on the
display, along with a countdown indicating the status of
the cycle in progress.
Once the cycle has been completed, the door remains
locked until the temperature inside the oven has
returned to a safe level.
. MINUTEMINDER
When the oven is switched off, the display can be used
as a timer. To activate this function, make sure that the
oven is switched off and press
flash on the display.
Press or to set the length of time you require and
then press to activate the timer.
MINUTE-MINDER
An audible signal will sound and the display will
indicate once the minuteminder has finished counting
down the selected time.
Please note: The minuteminder does not activate any of the
cooking cycles. Press
timer.
Once the minuteminder has been activated, you can
also select and activate a function.
Press to switch on the oven and then select the
function you require.
Once the function has started, the timer will continue to
count down independently without interfering with the
function itself.
Please note: During this phase, it isn't possible to see the
when done: the oven
or : The
or to change the time set on the
icon will