Husqvarna R112iC Manual De Usuario página 26

Problem
The cutting result is unsatisfacto-
ry.
Display LED light signals
The LED lights on the display will give signals if there
is a fault or if the operation conditions are not obeyed.
To do a check of the operation conditions on
Refer to
page 13 .
1
4
Mode Signal
Drive mode The operator
presence control
LED light (4)
flashes 5 times.
26
Cause
The blades are blunt.
The grass is long or wet.
The cutting deck is not parallel to
the ground.
There is grass blockage in the
cutting deck.
The tire pressure is different on
the right and left sides.
The product is operated at a too
high speed.
The motor speed is too low.
2 3
5
6
Situation
The operator left
the seat when the
product is used.
Action
To examine the blades on page 23 .
Refer to
Refer to To get a good result on page 20 .
To do a check of the parallelism of
Refer to
the cutting deck on page 23 .
To clean the product on page 21 .
Refer to
Tire pressure on page 22 .
Refer to
Speak to an approved service workshop.
Speak to an approved service workshop.
Mode Signal
Standby mode The operator
presence control
LED light (4)
flashes.
The battery LED
lights (5) 1–4
flashes.
The parking brake
indicator LED
light (1) flashes.
The blades en-
gaged indicator
LED light (2)
flashes.
The standby indi-
cator (3) and the
warning indicator
(6) flashes until
the start button is
released.
The parking brake
is engaged and
the standby indi-
cator (3) and the
warning indicator
(6) flashes until
the start button is
released.
Situation
The start button
is pushed when
there is no opera-
tor in the seat.
The start button
is pushed when
the charger is
connected.
The start button
is pushed but the
parking brake is
not applied.
The start button
is pushed when
the cutting deck is
lowered.
The start button
is pushed when
the forward or
rearward pedal is
pushed down.
Speak to an ap-
proved service
workshop.
1263 - 006 - 27.04.2022