Tire Pressure; To Examine The Steering Cables; To Remove The Mulch Plug - Husqvarna R112iC Manual De Usuario

2. Lift the front of the battery cover and push it
rearward.
3. Install in the opposite sequence.
To remove and install the cutting deck cover
1. Release the clip (A) on the cutting deck cover.
C
A
2. Remove the cutting deck cover (B).
3. Install in the opposite sequence.
Note:
Make sure that the flange (C) is in the
correct position.

To examine the steering cables

1. The steering cables are correctly tightened if you can
manually move them 5 mm up or down in the groove
on the steering collar.
22
B
2. If the wires are too loose, let an authorized service
agent adjust them.
To do a check of the parking brake
1. Park the product on a hard surface that slopes.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Push the parking brake pedal down (A).
A
3. Push and hold the lock button (B) and release the
parking brake pedal while the button is pushed.
4. If the product starts to move, let an approved service
agent adjust the parking brake.
5. Push the parking brake pedal again to release the
parking brake.

Tire pressure

The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.

To remove the mulch plug

You find the mulch plug on the bottom side of the cutting
deck.
1. Remove the cutting deck. Refer to
cutting deck on page 16 .
B
To remove the
1263 - 006 - 27.04.2022