Grizzly BRM 51-170 A-OHV Q-360 E-Start Traducción Del Manual De Instrucciones Original página 103

• Mow only in daylight or with good ar-
tificial lighting. An unlit working area
can result in accidents.
• If possible, avoid using the equipment
on wet grass.
• Always ensure secure positioning,
particularly on hillsides, landfills,
ditches or dykes. This will give you
better control of the equipment in un-
expected situations.
- Always work across the slope,
never upwards or downwards.
- Take particular care when changing
the direction of travel on the slope.
- Do not mow on excessively steep
slopes (max. 10°).
• Run the equipment only at walking
speed.
• Take particular care when turning the
equipment around or pulling it towards
you.
• Stop the cutting tool if the equipment
has to be tipped up for transportation
over a surface other than grass and
when moving the equipment from and
to the surface to be mown.
• Do not use the equipment with dam-
aged safety equipment or guards or
with no safety equipment attached,
e.g. impact protection and/or grass
catchers. This ensures that the equip-
ment remains safe.
• Do not change the engine regulator
setting and do not over-rev it. This
may damage the equipment.
• Before starting, the engine, disengage
all cutting tools and drives.
• Start or operate the start switch with
care and in accordance with the
manufacturer's instructions. Ensure
sufficient space between feet and the
cutting tool. Risk of injury.
• When starting or activating the en-
gine, do not tip the equipment unless
the equipment has to be lifted for
this procedure. In this case, tip the
equipment only as far as is absolutely
necessary and lift only the side that is
away from the user.
• Do not start the engine when standing
in front of the ejection channel.
• Switch on the engine in accordance
with the instructions and only if your
feet are a safe distance away from the
cutting tools.
• Do not place hands or feet under ro-
tating parts. Always keep away from
the ejection opening. A moment of
carelessness when using the equip-
ment may result in serious injury.
• Do not leave or carry the equipment
when the engine is running.
• Switch off the engine, take out the
spark plug connector and ensure that
all moving parts are still:
- Before releasing blockages or re-
moving obstructions in the ejection
channel;
- Before checking, cleaning or work-
ing on the equipment;
- If a foreign body is struck. Look for
damage to the equipment and carry
out the necessary repairs before re-
starting and working with the equip-
ment;
- If the equipment starts to vibrate
unusually strongly, an immediate
check is required.
• Switch off the engine
- When leaving the equipment;
- Before refuelling;
• Close the throttle valve when stopping
the engine.
• Do not leave the equipment unat-
tended in the workplace.
• Do not work with equipment that is
damaged or incomplete or has been
converted without the approval of the
manufacturer.
GB
103