Dry Ironing - Qilive Q.5815 Manual De Instrucciones

IMPORTANT: DO NOT add any substances into the water tank, such as starch, fabric
EN
softener, chemical additives, scented oils, hot water, descaler, or vinegar.

5.3. DRY IRONING

When dry ironing, do not press the Steam trigger (10).
1. Ensure the Temperature dial (9) is in the "MIN" position, and then plug the power
cord into a suitable wall socket to turn the appliance on.
2. Turn the Temperature dial (9) to select the temperature according to the care label
or fabric type of the garment (
SETTINGS GUIDE). The heating-up indicator light (1) will illuminate.
3. When the heating-up indicator light (1) goes off, remove the iron from the thermal
insulated platform (11) and start ironing.
4. Stop ironing when the heating-up indicator light (1) illuminates, and continue
ironing when it goes off.
5. Once you have finished using the appliance, turn the Temperature dial (9) to "MIN"
and unplug the power cord from the wall socket to turn the appliance off.
CAUTION! When the iron is heating up, resting or cooling down, always place
the iron on the thermal insulated platform (11).
5.4. HORIZONTAL STEAM IRONING
1. Fill the water tank (→ FILLING THE WATER TANK).
2. Ensure the Temperature dial (9) is in the "MIN" position, and then plug the power
cord into a suitable wall socket to turn the appliance on.
3. For steam ironing, set the Temperature dial (9) to
the care label or fabric type of the garment (→ TEMPERATURE AND STEAM
SETTINGS GUIDE).
4. When the heating-up indicator light (1) goes off, remove the iron from the thermal
insulated platform (11) and start ironing.
5. Press the Steam trigger (10) to produce a soft flow of steam when required.
To apply Steam Shot, press the Steam trigger (10) two times quickly. The
6.
soleplate will emit a strong burst of steam to help remove stubborn wrinkles. Wait
a few seconds before repeating again.
7. Stop ironing when the heating-up indicator light (1) illuminates, and continue
ironing when it goes off.
8. Refill the water tank when the water level is low. Turn the Temperature dial (9) to
"MIN" and unplug the power cord before refilling (→ FILLING THE WATER TANK).
9. Once you have finished using the appliance, turn the Temperature dial (9) to "MIN"
and unplug the power cord from the wall socket to turn the appliance off.
CAUTION! Hot water may drip from the soleplate if the Temperature dial (9) is
set below the minimum temperature
temperature will not be hot enough to produce steam if the iron is set below this
minimum.
MAX) (→ TEMPERATURE AND STEAM
to
required for steam ironing. The
8
or higher, according to