Chapter 15 - Dismantling/Demolition; Scrapping Of The Machine; Chapter 16 - Emergency Situations; Proceed As Follows - Lavorwash SWL 990 ET Manual De Instrucciones

CHAPTER 15 - DISMANTLING/DEMOLITION

ATTENTION: Dismantling and demolition are a customer's responsability. These
operations must be performed in accordance with applicable regulations, handing the
entire machine or its components to companies specialised in such services.
As the owner of electrical or electronic equipment, the law (in accordance with the EU Directive 2012/19/EU on
waste from electrical and electronic equipment and the national laws of the EU Member States that have
implemented this Directive) prohibits you from disposing of this product or its electrical / electronic
accessories as municipal solid waste and obliges you to make use of the appropriate waste collection facilities .
The product can be disposed of by returning it to the distributor when a new product is purchased .
The new product must be equivalent to that being disposed of .
Disposing of the product in the environment can cause great harm to the environment itself and human health .
The symbol in the figure indicates the urban waste containers and it is strictly prohibited to dispose of
the equipment in these containers . Non-compliance with the regulations stipulated in the Directive
2012/19/EU and the decrees implemented in the various EU Member States is administratively punishable .
If the machine will no longer be used, remove the batteries and dispose of them in accordance with the eco-
compatibility regulations as set forth in European standard 2013/56/EU or deposit them in an authorized
collection centre .
To dispose of the machine, comply with the current laws where it is used:
- disconnect the machine from the mains and clean it after emptying any liquids;
-separate the machine into groups of homogeneous materials (plastics in accordance with the recycling
symbol, metals, rubber, packing) .
For parts containing different materials, contact the competent authorities; Each homogeneous group must be
disposed of in accordance with recycling laws . In addition, it is recommended to eliminate those parts of
the machine that may be dangerous, especially for children .

CHAPTER 16 - EMERGENCY SITUATIONS

IN THE EVENT OF ANY EMERGENCY SITUATIONS SUCH AS, FOR INSTANCE: THE MACHINE HAS ACCIDENTALLY
BEEN DRIVEN OVER POWER CABLES AND THESE HAVE WRAPPED AROUND THE CENTRAL BRUSH OR SIDE
BRUSH, OR AN UNUSUAL NOISE IS HEARD COMING FROM INSIDE THE MACHINE OR ENGINE, HOT MATERIALS,
INFLAMMABLE LIQUIDS, CHEMICAL MATERIALS IN GENERAL, POISONS ETC . HAVE BEEN PICKED UP ETC:
1 . Disengage the traction
2 . Hardly press the brake pedal
3 . Switch off the engine by the key on the dashboard or simply by leaving the driving seat as the safety
micro switch under the seat will automatically turn the engine off.
4 . After picking up the above materials, remove the container (bin) part. 1 and 2 fig. 7 and clean it, wearing
gloves and mask to protect the airways . Follow the instructions in the "collection bin" paragraph .

SCRAPPING OF THE MACHINE

PROCEED AS FOLLOWS:

33