Important; Chapter 15 - Extraordinary Maintenance; Chapter 16 - Spare Parts; Chapter 17 - Dismantling And Demolition - Lavorwash SWL R 1300 Manual De Instrucciones

Every 200/300 hours of work, or when required, clean the waste container . It is advisable to perform this
operation when cleaning the filters (para. 14.9).
Proceed as follows:
Lower the waste container and open the flap. Then stop the motorsweeper (para. 8.6)
Remove the filters as described in paragraph 14.9.
Remove any waste in the container .
Once the operation is completed, proceed to reassemble the filters as described in paragraph 14.9.
IMPORTANT: It is highly recommended to clean the filter container without the use of
water or to allow the motorsweeper to dry completely before resuming cleaning
operations.

CHAPTER 15 - EXTRAORDINARY MAINTENANCE

EXTRAORDINARY MAINTENANCE ARE ALL OPERATIONS THAT HAVE NOT BEEN
MENTIONED IN THIS BOOKLET; THEY MUST THEREFORE BE CARRIED OUT BY
SPECIALIST ASSISTANCE PERSONNEL, APPOINTED FOR THIS PURPOSE (SEE BOOKLET
COVER).

CHAPTER 16 - SPARE PARTS

For the replacement of machine parts, refer to the list of spare parts provided by the Manufacturer .

CHAPTER 17 - DISMANTLING AND DEMOLITION

DISMANTLING OR DEMOLITION MUST BE CARRIED OUT BY THE CUSTOMER, IN FULL
COMPLIANCE WITH THE REGULATIONS IN FORCE ON THE MATTER, CONFERRING THE
ENTIRE MACHINE OR THE PARTS THAT COMPOSE IT TO COMPANIES ASSIGNED TO
SUCH SERVICES.

CHAPTER 18 - DEFECTS / CAUSES / SOLUTIONS

There are two fundamental defects:
•
the machine creates dust during use,
•
the machine leaves dirt on the ground .
There can be many causes, but with careful use and good routine maintenance they will not occur . The most
common and frequent problems that can occur are listed in the following table .
DEFECTS
The machine creates dust.
CAUSES
Suction closed .
Filter clogged .
Damaged filter
Filter inserted incorrectly .
Continuous use of the side brush .
Damaged side seals .
71
SOLUTIONS
Activate the suction (para . 8 .11)
Clean it, "shake" it with the
appropriate tools and if necessary
remove it and clean it thoroughly .
Replace it .
Fit it with the appropriate seal and
make sure that it is well inserted and
tightly in place with the appropriate
fasteners .
Use the side brush only for the
cleaning of edges, profiles and
corners .
Adjust or replace them .