Energeeks EG-AL003 Manual Del Usuario página 19

EG-AL003
Introduction
Two-way door alarm will detect and alarm immediately when door and window
is open, also can program with remote control and detector function. Magnetic
stripe can be placed on the two side of host, Under the arming condition, door
alarm can be alarming directly when magnet is separated from door sensor to
prevent the intruder from doors and windows, it also can be wireless connect
motion detectors, door sensors, smoke detectors, gas detectors, panic buttons
and other accessories.
Function
Key mode: short press---less than 3s,
long press---more than 3s
Short press [ ] button to arm the host. After arm status, enter the sensor host

4 digital keyword continuous to disarm host.
Arm: Four LED lights in host flashing once and host "Di" , arm successful;
Disarm: Four LED lights flash twice and the host "DiDi" , disarm successful.
When use the door alarm alone
Slide of the switch of [Alarm / Doorbell] and change the prompt voice of the
host. Slide the switch of [Home / Outl] and change the mode of the host.
Switch to Out model, the host disarm first, and enter into delay arm status(
delay 30 seconds). Four led light will flash once every seconds in delay
time, after 30 second, host "di" once, means arm successful.
Out model and arm the host, when the door sensor is triggered, the host will
delay alarm 30 seconds. In delay alarm status, Led will flash three times every
seconds, after 30 seconds, the host will alarming. When the host in doorbell mo-
del, the host will broadcast the doorbell tone immediately. Switch Home model,
the host arm success immediately.