Energeeks EG-AL003 Manual Del Usuario página 23

EG-AL003
Password modification:
Remove the battery, long press one of four [number] key means power on,
the door alarm host "beep, beep..." six sound, the four LED long light, enter
the password to modify the state. Trigger the [number] key to set a 4-digit
password, trigger a number, the corresponding digital light will flash, when you
enter the fourth digit, press [ ] key to confirm, that will automatically exit the

settings, password set up successfully.
Note: If the setting is not set beyond 20 seconds or the password is not set,
the host will automatically exit the password setting. The host will still save the
password before setting (the factory password is 1234).
Installation
Interval < 10mm
23