Energeeks EG-AL003 Manual Del Usuario página 20

User Manual
Trigger the door alarm when it was armed and at Home status, the host will
give an prompt tone. (At Home status, you can arm the host just switch to [ ]

on the host)
NOTE: The host will give prompt tone and LED flash when you trigger it at Arm
status. To disarm it, you need to input the 4-digit password.
NOTE:
1. If the password is incorrect, the host will give prompt tone 'beep~beep~beep'
to require you to input again.
2. During the password input, you can press [ ] to input the password again.

3. If the password interval is too long, the host will require you to input again.
Add Detectors
Long press [ 1 ] ,the first LED light is on,host enter setting status,then trigger
the detector,the first LED light flash twice,the host "beep" twice means add
successful. The LED indicator light flash once,the host "beep" once means add
before.The LED indicator light flash 3 times,the host "beep" 3 times means the
host can't add any more sensors.
Delete Detectors
Long press [ 1 ] , the first LED light is on,host enter setting status,then long press
[ 1 ] ,the host indicator light flash 4 times,the host "beep" 4 times,it means delete
the detectors in 1 zone. According to the above method can delete the detectors
in 2,3 and 4 zone.
The door alarm host can add as much as 10 Remote controls ,and 10 detectors
in each zone.
NOTE:
1) Only in the disarm statue, door alarm can add remote control and sensor,o-
therwise it will report error("beep" error tone 3 times continuously)
2) In setting statue,short press any button or 20 seconds without any operation,-
the host will exit the setting statue.
20