Factory Reset - Energeeks EG-AL003 Manual Del Usuario

User Manual
Normal zone: The Panel only works on the arming status. When disarming, there
is no response.
Emergency zone: No matter in what status, when sensor with this zone is trig-
gered, it will alarm.
Chime Zone: No matter in what status, when sensor with this zone is triggered,
a welcome doorbell will be ring as notification.
Welcome Zone: Working on the disarming status, when sensor with this zone is
triggered, a 'welcome' sound will be played.
NOTE:
1. Door alarm is four normal zones in default , the alarm time is 2min, no delayed
after alarm;
2. Trigger the detector, the sensor has a warning sound, the corresponding zone
indicator light will flash, suggesting that the user which zone detector is trigge-
red (the host alarm sound, first, four LED flash a few seconds at the same time,
then flash for the Zone LED lights).

Factory Reset

Take off the battery, then hold the [ ] and restart the sensor. The led light

will be activated and after 10 times of sound 'beep..beep', the led light will be
flashed then the sensor is recovery, All accessories was cleaned , the host is
in disarming status.
22