Tips For Great Results; Quick Tips - KitchenAid KSB5000 Manual De Instrucciones

TIPS FOR GREAT RESULTS

Quick tips

Using the Blender
• Stop the Blender before using utensils in
the pitcher. Use a rubber spatula to mix
ingredients only when the Blender is off.
Never use any utensil, including spatulas,
in the pitcher while the motor is running.
• The Blender is capable of handling hot
ingredients. For best results, when
blending hot food or liquids, do not fill
the Blender pitcher to the top. Secure
the lid, remove the center ingredient
cap and place a towel over the top.
• The blender is not intended to be
used as a heating device.
Magnetic blending
• Be aware that the Blender jar and Blender
base contain magnets that may attract
other items. For example, the jar may
attract adjacent metal utensils when
placed on a countertop.
• Metal items may also be attracted to
the Blender base if jar is not in place.
However, the Blender will not run
without the jar and lid in place.
• Check that jar bottom is free of small
magnetic debris before each use.
Blending on variable speed
• For mixtures blended on the Variable
Speeds setting, start the blending process
at a lower speed to thoroughly combine
the ingredients. Then increase to a
higher speed, as desired. You'll find that
the pre-set recipe programs will make
blending easier by varying the speed level
automatically.
12
• Because the Blender can work without
user intervention, the Variable Speed
function will automatically turn off after
approximately 2 minutes to ensure it does
not run longer than intended and the
recipe does not get overblended. If you
want to blend longer, reset the Blender
to the "OFF/O" position and run it again
as needed.
Using the ingredient feed
• If desired, you can remove center
ingredient cap to add ingredients while
the Blender is operating.
• The ingredient cap and funnel will need
to be washed even if ingredients are not
added through the ingredient feed.
• For thorough processing of ingredients,
add them early in the cycle so that the
Blender can process them fully.
• If chunks of fruit and vegetables are
desired, add the ingredients towards
the end of the blending cycle.
• If the ingredient cap does not fully
seat, make sure the funnel is fully in
the down position. If you are having
trouble, rotate either the funnel or the
cap until you find the correct position.
• Wipe out inner funnel liner after each use.
Crushing ice
• Ice directly from the freezer will crush
better than partially melted ice for snow.
• Smaller ice cubes can be chopped or
crushed faster than large ones.
• For best results, crush ice by adding
it through the ingredient feed as the
Blender is running. The recommended
speed for crushing ice is the lowest
selection on the variable speeds setting.