Diamond DCS9 Manual De Instrucciones página 12

P a g e 1 0
4
5
6
7
All manuals and user guides at all-guides.com
4. Remove the draining pipe (if already installed) and
apply the coupling (supplied) between the draining
tang and the motor pump inlet by fastening the parts
through
tightening it.
5. Fasten the draining pipe (supplied) through the
special clamp (supplied) at the motor pump outlet
(there is a rear slit for the passage of the draining
pipe out of the machine).
Connect the motor pump to the supply mains using
6.
the supplied cables (close to the motor pump). Follow
the instructions shown on the attached wiring
diagram (0;43-44).
7. The draining program must be actuated by switching
micro-switch no. 2 (on the electronic card) to "on".
ASSEMBLY INSTRUCTIONS
the clamps (supplied) and perfectly