Diamond DCS9 Manual De Instrucciones página 5

ASSEMBLY INSTRUCTIONS
4
5
6
All manuals and user guides at all-guides.com
4. Fasten the measuring device on the front frame,
using the special holes and fastening screws.
5. Connect the junction to the measuring device
through the supplied piping using the special
clamps.
Connect the measuring device to the supply
6.
mains using the supplied cables close to the
same device. Follow the instructions shown on
the attached wiring diagram.
7. TESTING:
Check that the measuring device starts at the
first tank filling and any time the machine
supplements the water into the boiler, that is, at
any rinsing.
Note: for adjustments, follow the instructions in
the user manual at chapter "Adjustments and
checks".
P a g e 3