Diamond DCS9 Manual De Instrucciones página 16

P a g e 1 4
8
7
2m
6
9
10
11
All manuals and user guides at all-guides.com
7
8
10
D1
ASSEMBLY INSTRUCTIONS
8. Connect the timer as shown in the picture, using the
electrical system's pre-wiring
timer).
• Adjust time:
Function "D1"
Scala "2m"
Setting"10"
9 Alteration for models with electronic control
For the models with electronic control just connect the
wire shown in the figure to the normally open contact of
the free fastons of the cycle start switch.
Connect the electric pump to wires 44 and 0.
The electric drain pump automatically starts every time
the machine fills and/or rinses.
All you have to do to drain the tank is turn off the
machine, remove the overflow and operate the
automatic start switch.
The electric pump turns off automatically after about
2'30".
10 TESTING:
The electric discharge pump activates during the
filling up and rinsing cycles.
To discharge the appliance, it is necessary to switch
it off by pressing the "line" button, engage the "cycle"
button, and hence remove the overflow cap. The
electric discharge pump stops automatically. Ensure
hydraulic joints do not leak.
.
11. Max. position of the wall draining "A" max= 820
mm.
(located near the