Assembling And Adjustments; Assemb Ly - Husqvarna DM650 Manual De Instrucciones

Assemb ly

W ARNING! The machine should be
!
switched off with the power cable
disconnected from the outlet.
Assemb ling on stand
• See instructions in the operator' s manual for the
stand in question.
Fitting the drill bit
CA UTION! The drill bit and the
!
surrounding area is very hot after use.
Leave machine to cool off before
removing the drill bit. Use protective
gloves.
• Fit the supplied friction ring on the spindle shaft.
NO TICE! The friction ring is used to prevent damage on
the shaft and the gear box during the dismantiling of the
drill bit.
• Assemble the drill and make sure it is fastened
properly.
6 – English

ASSEMBLING AND ADJUSTMENTS

Dismantling/c hanging the drill bit
• Use the accompanying 32 mm wrench to lock the
spindle axle.
• Undo the drill by turning it clockwise.
NO TICE! Fierce knocks can damage gearbox and drill
stand.
Connect the cooling water
• Connect the water hose to the water supply.
Connect a po wer cable
• Connect the machine to the power unit.
• Connect the power unit to a grounded outlet
• Turn on the power unit switch.