SPORTSTECH sBike Manual De Instrucciones página 28

6.3 INSERTING THE FRONT TUBE
14
• On the lower part of the front tube ('14'), loosen the rubber band on the connector ('127').
• First person: Hold the front tube ('14') over its position on the main housing, as shown in the figure.
• Second person: On the main frame, loosen the rubber band on the connector (128').
• Insert the plug '128' into the connector '127'. Prevent pinching of fingers.
• Pull the knob ('Kn1') outwards against the spring force. If necessary, loosen it beforehand by turning it
a little to the left.
• Carefully lower the front tube ('14') into the main housing ('50'). Do not clamp the cable. Observe the
required minimum depth.
• Let go of the knob. Make sure that the locking pin on the knob snaps into one of the holes of the front
tube inside the main housing.
• Tighten the knob with your hand.
28
127
128
Kn1
50